DS2413 1-Wire Two GPIO Controller Breakout

You39re too cool for I2C, and SPI has so many wires, 8-bit parallel... how can that be fashionable!? You are a 1-Wire kinda gal, and you want more 1-Wire breakouts in your life to complement all of your great engineering. Well rock on, because here you go, it39s a 1-Wire controller with two open-drain GPIO. You can put as many of the DS241339s a...

€ 7,95 € 6,57
Ontvang bij aankoop
3 SOS spaarpunten
(t.w.v. €0,30)i
Niet in voorraad
Gratis verzenden
Bezorgtijd niet op voorraad
You39re too cool for I2C, and SPI has so many wires, 8-bit parallel... how can that be fashionable!? You are a 1-Wire kinda gal, and you want more 1-Wire breakouts in your life to complement all of your great engineering. Well rock on, because here you go, it39s a 1-Wire controller with two open-drain GPIO. You can put as many of the DS241339s as you want on a single I/O line, each one is uniquely addressable and shares the single I/O pin happily. The two controllable I/O lines (PIOA and PIOB) can be used as inputs or outputs. They are open-drain, so if you want to power an LED or something, you39ll need a remote power supply (see Maxim39s product page for more details) We have a basic Arduino sketch that uses the OneWire library to communicate with this chip. Don39t forget to add the 4.7Kohm resistor from I/O to your 1-Wire controller power supply (3.3V - 5V) on the Arduino side of the wires. DS2413 1-Wire Two GPIO Controller Breakout (445)
Meer informatie
Geschikt voor n.v.t.
Reviews
Er zijn nog geen reviews voor dit product Schrijf de eerste review over dit product
Je plaatst een review over: DS2413 1-Wire Two GPIO Controller Breakout as
Uw waardering

Vragen over dit product
Meer van dit merk