Stereo 2.8W Class D Audio Amplifier - I2C Control AGC - TPA2016

A mini class D with AGC and I2C control? Yes please! This incredibly small stereo amplifier is surprisingly powerful. It is able to deliver 2 x 2.8W channels into 4 ohm impedance speakers ( 10 THD) and it has a i2c control interface as well as an AGC (automatic gain control) system to keep your audio from clipping or distorting. If you don39t wa...

€ 12,95
Ontvang bij aankoop
6 SOS spaarpunten
(t.w.v. €0,60)i
Niet in voorraad
Gratis verzenden
Bezorgtijd niet op voorraad
A mini class D with AGC and I2C control? Yes please! This incredibly small stereo amplifier is surprisingly powerful. It is able to deliver 2 x 2.8W channels into 4 ohm impedance speakers ( 10 THD) and it has a i2c control interface as well as an AGC (automatic gain control) system to keep your audio from clipping or distorting. If you don39t want to use I2C to control it, it does start up on with 6dB gain by default and the AGC set up for most music playing. We do suggest using it with a microcontroller to configure it, however, since its quite powerful. Settings are not stored in the chip, so you39ll need to adjust any gain AGC amplification settings every time the amp is powered up. Inside the miniature chip is a class D controller, able to run from 2.7V-5.5VDC. Since the amp is a class D, it39s incredibly efficient (89 efficient when driving an 8 speaker at 1.5 Watt) - making it perfect for portable and battery-powered projects. It has built in thermal and over-current protection but we could barely tell if it got hot. This board is a welcome upgrade to basic LM386 amps! The inputs of the amplifier go through 1.0uF capacitors, so they are fully 39differential39 - if you don39t have differential outputs, simply tie the R- and L- to ground. The outputs are Bridge Tied - that means they connect directly to the outputs, no connection to ground. The output is a 300KHz square wave PWM that is then 39averaged out39 by the speaker coil - the high frequencies are not heard. All the above means that you can39t connect the output into another amplifier, it should drive the speakers directly. Comes with a fully assembled and tested breakout board with 1.0uF input capacitors. We also include 3.5mm screw-terminal blocks so you can easily attach/detach your speakers, and some header in case you want to plug it into a breadboard. Speakers are not included, use any 4 ohm or 8 ohm impedance speakers. Our awesome tutorial and Arduino library will let you set the AGC configuration (you can also just turn it off), max gain, and turn on/off the left right channels all over I2C! You will be ready to rock in 20 minutes! Stereo 2.8W Class D Audio Amplifier - I2C Control AGC - TPA2016 (610)
Reviews
Er zijn nog geen reviews voor dit product Schrijf de eerste review over dit product
Je plaatst een review over: Stereo 2.8W Class D Audio Amplifier - I2C Control AGC - TPA2016 as
Uw waardering

Vragen over dit product
Meer van dit merk